Role of flame localization in wavemaker regions on the suppression of combustion instability in turbulent partially-premixed methane flames

Abhishek Kushwaha; Bjarne Lieth; Isaac Boxx

Home/Archive/arXiv

arXiv · 2609.39502

Role of flame localization in wavemaker regions on the suppression of combustion instability in turbulent partially-premixed methane flames

Abhishek Kushwaha·Bjarne Lieth·Isaac Boxx

View original source ↗Read source document ↗Export metadata ↓

Abstract

The interaction between flame dynamics & hydrodynamic instabilities plays a fundamental role in determining the stability of swirl-stabilized combustors. In the present study, we investigate the hypothesis that spatial overlap between flame & wavemaker region is a necessary prerequisite for combustion stability in flows characterized by a wavemaker region. To test the hypothesis, a low-momentum secondary methane injection was introduced through circumferential holes located on the centerbody of a swirl-stabilized burner. The injection velocity was maintained below 5\% of bulk flow velocity to minimize momentum-induced modifications of flow field while selectively redistributing heat release. In addition, an equivalent amount of fuel was diverted from primary fuel supply to secondary injection ports, known as fuel-staging, to isolate the effects of flame relocation from those of the total fuel flow rate. The introduction of secondary injection produced a transition of the flame from M-shaped to V-shaped structure, while fuel-staging yielded a similar flame response, demonstrating that observed behavior results primarily from redistribution of heat release. Linear stability analysis revealed that wavemaker region remains near inlet of the combustion chamber. Moreover, flame root transitions from a lifted M-flame to attached V-flame and consistently stabilizes at radial position corresponding to the identified wavemaker region. The coincidence of flame attachment & wavemaker location under stable operating conditions provides strong experimental evidence that flame stabilization is governed by their spatial overlap rather than by a modification of the underlying hydrodynamic instability. The proposed framework provides new insight into the coupling between flame stabilization & hydrodynamic instability & offers practical guidance for the design of stable, low-emission combustion systems.

Explore related subjects

physics.flu-dyn

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Abhishek Kushwaha, Bjarne Lieth, Isaac Boxx. 2026-09-30. Role of flame localization in wavemaker regions on the suppression of combustion instability in turbulent partially-premixed methane flames. https://arxiv.org/abs/2609.39502

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Gas radiation and the gravity limit of flicker in a co-flowing hydrogen jet diffusion flame

Although weak at normal gravity, gas radiation sets the gravity at which a co-flowing hydrogen jet diffusion flame stops flickering. Flamelet-based simulations with unity Lewis numbers, which reproduce the flicker frequency measured by femtosecond coherent anti-Stokes Raman scattering within 4%, are combined with local stability analysis. At one tenth of normal gravity, the adiabatic flame flickers, the radiating flame does not, and switching the emission off restores flicker. Radiation acts through two mechanisms that do not weaken at reduced gravity. The hot outer layer loses buoyancy in proportion to the gas residence time, and a disturbance that displaces the flame also displaces its emission, which damps the disturbance on the lean flank (displaced-emission damping). Freezing the radiative source, which removes only its response to disturbances, slows the downstream recession of the oscillation more than tenfold. Both mechanisms slow the upstream spreading of disturbances. This spreading, competing with the co-flow, sets the onset location and the critical co-flow. Without radiation, the spreading speed scales with the square root of gravity; its radiative reduction does not. At reduced gravity, the flicker limit therefore becomes a straight line relating the square root of the co-flow Froude number to a radiation number, the ratio of buoyant to radiative time scales. The calibrated line places the critical gravity for the experimental co-flow at 0.13 times normal gravity, 2.6 times the adiabatic value. It correctly predicted whether two further flames keep flickering. Beyond the limit, transient wave packets can mimic flicker throughout a short drop-tower test.

physics.flu-dyn↗

arXiv2026

High-fidelity Three-Dimensional Flow Field Reconstruction Driven by Turbulent Fluid Dynamics

High-fidelity three-dimensional turbulent flow fields are essential for scientific and engineering analyses, yet obtaining them through direct numerical simulation or high-resolution measurements remains expensive. Super-resolution reconstruction from coarse-grained data therefore offers a promising alternative, but remains fundamentally challenging because fine-scale structures are intrinsically three-dimensional and dynamically coupled across scales. Existing data-driven approaches still struggle to recover multiscale volumetric structures and their coherent temporal evolution. To address these limitations, we propose a turbulence-aware framework for time-resolved three-dimensional flow reconstruction. The framework couples a multiscale neural operator, designed to recover volumetric structures, with a state space model to promote temporal consistency in the reconstructed dynamics. In addition, Navier-Stokes residuals are incorporated as soft constraints to regularize the reconstruction toward physically plausible dynamics. A mixture-of-experts mechanism is also introduced to support unsupervised adaptation to unknown coarse-graining. Across evaluations on canonical turbulent systems and atmospheric reanalysis data, the proposed framework reduces reconstruction errors relative to learning-based and classical baselines, while better preserving multiscale spatial structure and coherent temporal evolution. These results validate the effectiveness of the proposed framework in reconstructing high-fidelity three-dimensional flow fields from coarse-grained data.

physics.flu-dyn↗

arXiv2026

One-way pressure-independent valves with hysteresis and chattering

We propose a model for the one-dimensional isothermal gas flow through a valve in a pipe. The valve aims at keeping the outgoing flow in an assigned interval; moreover, its opening and closing depend on a further parameter. The model is realized by a system of two conservation laws with suitable conditions coupling the ingoing and the outgoing flow. We study the corresponding Riemann problem, where non-classical shocks show up. Although simple, the model allows to study two key oscillatory behaviors of the flow, which are due, respectively, to the chattering of the valve, especially seen in the numerical simulations, and to the stabilizing hysteresis induced by the valve operation. We characterize the states leading to chattering and show how they depend on the parameters of the model. Through several numerical simulations, we study the interplay between the two above phenomena.

physics.flu-dyn↗