Influence of a vertical-wall leading edge on bouncing and escape bubble rising regimes

Abstract

This work investigates deformable gas bubbles rising near a vertical wall in ultrapure water, focusing on how the position of the wall leading edge affects their near-wall dynamics. Two configurations are considered: (i) a wall extending from 11--25 bubble diameters below the bubble injection point, so that the bubble rises under the continuous influence of the boundary; and (ii) a wall whose leading edge is located 144 mm above the injector, corresponding to approximately 80--180 bubble diameters, allowing the bubble to reach its terminal velocity before entering the wall-bounded region. The results show that the wall leading-edge position influences both the transition from periodic bouncing (PB) to bouncing--tumbling--escaping (BTE) dynamics and the rebound frequency within the PB regime. When the wall leading edge is placed downstream, the onset of BTE occurs at smaller bubble sizes, corresponding simultaneously to lower Bond ($Bo$), Galilei ($Ga$), and Reynolds ($Re$) numbers. The Strouhal number ($St$) follows a similar decreasing trend in both configurations at low Bond numbers, but the two behaviours diverge for ($Bo \gtrsim 0.15$). For the PB regime, when the wall extends from the injector, $St$ approaches an approximately constant value of $St\simeq0.014$, whereas substantially lower values are measured for the downstream-wall configuration. The larger rebound amplitudes and longer return stages observed in the latter configuration account for lower frequencies. These findings indicate that the bubble dynamics depend not only on the conventional control parameters and wall separation, but also on the wall geometry and the associated pre-interaction bubble hydrodynamic history.