Passive transverse forcing of turbulent boundary-layer flow using sinusoidal surface grooves

Abstract

A surface geometry consisting of parallel, meandering streamwise grooves has been experimentally studied as an alternative means of passive transverse forcing of turbulent boundary-layer flow. Contrary to the original expectation, the flow does not exhibit a spanwise-uniform undulation aligned with the grooves; instead, a converging-diverging flow pattern results. This flow pattern can be attributed to the spanwise periodicity of the lateral pressure gradient. The forcing effect is found to initially increase with the groove amplitude, but it saturates when the groove slope becomes too steep. The observed induced flow, referred to as a Passive Stokes Layer (PSL), can be considered as being composed of an inertial (pressure-driven) outer solution generated by the displacement effect of the non-smooth surface geometry, and a viscous inner solution to accommodate the no-slip condition at the wall. The mechanism of transverse flow generation is elucidated by an inviscid flow model that relates the forcing to the surface geometric properties, with predictions in good agreement with the experimental results. Although a reduction in the near-wall turbulence levels over the groove surfaces is observed, no direct evidence for (mean) drag reduction is evident from the data. Instead, an estimate of the frictional drag potential is based on establishing a tentative relation to an equivalent spatial Stokes layer (SSL) induced by active wall forcing. This theoretical comparison indicates that the induced passive forcing is sufficient to act on the (active) spanwise forcing mechanism, but produces at most a few per cent of frictional drag reduction. Any potential savings are likely offset by pressure drag and other losses, so that, similar to active forcing, its potential for net drag reduction in practical applications is limited.