arXiv ScienceSearch

arXiv · 2409.04462

New parametric identification method for a preference model

Abstract

This article presents a contribution to multi-criteria decision support intended for industrial decision-makers in order to determine the best compromise between design criteria when working on risky or innovative products. In (RENAUD et al. 2008) we used the OWA operator (Ordered Weighted Average), a well-known multi-criteria analysis technique introduced by (YAGER 1988). The interest of this aggregation method is, beyond its ease of use, its ability to evaluate a product according to a single scale. When using the OWA method, the choice of criterion weights and their values remains an important and delicate operation. Indeed, the weights are not fixed by criterion but according to a level of utility (FISHBURN 1967). The weights can, in addition, be determined using different methods. A traditional approach consists in estimating the weights from an a priori selection of the most representative samples by an expert. We propose a new approach based on applied D-Optimality to determine the best sample. The results of the two approaches are compared. Indeed, in some multi-criteria decision problems, it is difficult to choose the method that best describes the behavior of the decision maker. As said above, the first part of this paper presents an original method based on D-optimality to determine the most representative set of samples to determine the decision parameters. This method has been applied and validated in an OWA approach. It has been shown that the accuracy and reliability of the method have been improved. Since the OWA application has been improved, the other goal of this paper is to verify whether the real decision maker has an OWA-based behavior or not. To achieve this, the D-optimality approach is applied to the MAUT (Multi-Attribute Utility Theory) approach to find the best set of samples. The results of the two methods are compared. Both approaches show that, while OWA better simulates the decision maker's behavior, there is still a gap between its scores and that of OWA. The question here is how to improve the accuracy of the score estimated by OWA compared to those given by the expert. Subsequently, a hybrid approach is tested, such as a linear combination of the MAUT and OWA approaches. The results obtained with this combination were found to be more accurate than those of OWA. However, we also tested the CHOQUET discrete integral approach. In other words, it is possible to find a model capable of better describing the decision maker's behavior.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

J Renaud, M Camargo, L Morel, C Fonteix. 2024-09-02. New parametric identification method for a preference model. https://arxiv.org/abs/2409.04462

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

Constrained Feedback Control of Nonlinear Systems via Approximate HJB and Control Barrier Functions

This paper presents a two-stage framework for constrained feedback control of input-affine nonlinear systems. Offline, an approximate value function for the unconstrained problem is computed, for example using Hamilton--Jacobi--Bellman (HJB)-based policy iteration. Online, the proposed quadratic program (QP) minimizes the pre-Hamiltonian evaluated using the approximate value-function gradient subject to safety constraints enforced by control barrier functions (CBFs). This architecture decouples performance optimization from constraint enforcement, allowing constraints to be modified without recomputing the value function. As in CBF-QP architectures based on control Lyapunov functions (CLFs), safety is enforced as a hard constraint; however, the performance objective targets approximate optimality rather than a prescribed Lyapunov decay. Numerical results on a linear 2-state hovercraft and a nonlinear 9-state spacecraft attitude-control problem show agreement with the constrained open-loop optimal control problem (OCP) benchmark in the linear case, and performance close to the OCP benchmark, improving on CLF-based controllers, in the nonlinear case.

eess.SY

Rao-Blackwellized Stein Gradient Descent for Joint State-Parameter Estimation

We present a filtering framework for online joint state estimation and parameter identification in nonlinear, time-varying systems. The algorithm uses a Rao-Blackwellization technique to infer joint state-parameter posteriors efficiently. In particular, conditional state distributions are computed analytically via Kalman filtering, while model parameters, including the measurement-noise covariance, are approximated using particle-based Stein Variational Gradient Descent (SVGD), enabling stable real-time inference. To handle parameters subject to physical constraints, we further introduce constrained variants that enforce them through an alternating direction method of multipliers (ADMM) splitting of the SVGD update, including nonlinear equality constraints that standard particle filters cannot readily handle. We derive a stability bound that relates the approximation error in the parameter posterior to the resulting error in the marginal state distribution. Performance of the proposed filters is validated on three case studies: a fed-batch bioreactor with Haldane kinetics and a damped pendulum, both under physical constraints, and a neural-network-augmented dynamic system. The examples cover parameter estimation under inequality and equality constraints and online neural-network training within a dynamical model.

eess.SY

Firing Rate Neural Network Implementations of Model Predictive Control

Human and animal brains perform planning to enable complex movements and behaviors, a process that can be effectively described using model predictive control (MPC). How could the brain physically implement MPC? In this work, we translate model predictive controllers into firing rate neural networks, offering insights into the nonlinear neural dynamics that underpin planning. We propose a constructive method; no training is required. This is done first applying the projected gradient method to the dual problem to derive a baseline neural network implementation. We then use factorization and contraction analysis to systematically generate alternative network architectures; in other words, we systematically generate hypotheses for how planning is done in the brain via neural dynamics. Finally, we present numerical simulations to study different neural networks performing MPC to balance an inverted pendulum on a cart (i.e., balancing a stick on a hand), including one example in which imposing sparse connectivity (a property observed in brain networks) does not degrade control performance.

eess.SY