arXiv Science⌕ Search
Home/Archive/arXiv

arXiv · 2006.13578

Universality of capillary rising in corners

Jiajia Zhou·Masao Doi
View original source ↗Read source document ↗Export metadata ↓

Abstract

We study the dynamics of capillary rising in corners. Using Onsager principle, we derive a partial differential equation that describes the time evolution of meniscus profile. We obtain both numerical solutions and self-similar solutions to this partial differential equation. Our results show that the advance of the meniscus front follows a time-scaling of $t^{1/3}$, in agreement with the experimental results and theoretical conjecture of Ponomarenko et al.

Explore related subjects

cond-mat.softphysics.flu-dyn

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Jiajia Zhou, Masao Doi. 2025-12-17. Universality of capillary rising in corners. https://doi.org/10.1017/jfm.2020.531

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

A pushing-pulling captive bubble method for repeatable measurement of dynamic contact angles underwater

Accurate measurement of dynamic contact angles in aqueous environments is essential for evaluating surface wettability. However, conventional captive bubble methods often suffer from limitations such as bubble instability and interference from needle wetting. In this study, we develop a pushing-pulling captive bubble method that enables stable and repeatable measurement of dynamic contact angles underwater without directly changing the bubble volume. In this method, a bubble is pushed against and detached from a surface by controlled vertical motion. This procedure allows stable observation of the contact line while suppressing bubble deformation and lateral movement. Dynamic contact angles were measured in both air and water using three types of surfaces: smooth surfaces, sandpaper-polished surfaces prepared to exhibit the Wenzel state in air and the reversed gas-liquid Wenzel state in water, and microstructured surfaces exhibiting hydrophobicity in air. For smooth and Wenzel surfaces, the dynamic contact angles measured in air and water showed similar values. Moreover, the modified captive bubble method exhibited reproducibility comparable to that observed in conventional captive bubble methods under the present experimental conditions. For microstructured surfaces, dynamic contact angle measurements in water had previously been difficult because an air layer remained trapped on the surface. In this study, ultrasonic degassing enabled dynamic contact angle measurements under fully wetted conditions, revealing behavior that differed significantly from that observed in air.

cond-mat.soft↗
arXiv2026

From Single-Chain Dynamics to Structure Formation: Dynamic Self-Consistent Field Theory and Molecular Dynamics of (Co)polymer Melts across Entanglement Regimes

Dynamic self-consistent field theory (DSCFT) provides an efficient continuum framework for studying structure formation in inhomogeneous polymer systems, but its predictive accuracy depends on the choice of the nonlocal mobilities. Here, we construct mobility functions for moderately and strongly entangled homopolymer and diblock copolymer systems from the relaxation dynamics of single-chain structure factors, based on molecular dynamics (MD) simulations of the Kremer-Grest model and analytical reptation theory. Single- chain mobilities are combined such that the resulting DSCFT accounts for the dependence of fluxes on local chain densities. The theory is then applied to the spinodal decomposition of symmetric homopolymer blends and diblock copolymer melts following a quench into the (micro)phase-separation regime. Predictions of DSCFT are systematically compared with MD simulations. Mobility functions derived from single-chain dynamics are found to reproduce the kinetics of structure formation more accurately than conventional Debye-type mobilities. We additionally investigate the influence of adding stochastic currents (noise) that are correlated according to the fluctuation-dissipation relation. At low noise levels, they enable the generation of equilibrium initial states and facilitate defect annealing. At high noise levels, however, nonolinear effects lead to discrepancies between DSCFT and MD simulations.

cond-mat.soft↗
arXiv2026

Slow Dynamics and the Geometry of Jammed Packings

Saddle points in the energy landscape of granular packings dominate the discrete steepest descent dynamics and ultimately determine the path that an out of mechanical equilibrium packing will follow and the resulting stable minimum that it will find. The saddle points that ultimately determine the resulting minima tend to be low-index saddle points. For models with an analytic energy landscape, such as the $p$-spin model, the steepest descent minimization path is affected by higher-index saddle points, which pull the system towards saddle points of decreasing index before arriving at the minima. Here, we examine the steepest descent minimization path of granular packings and compare them to the $p$-spin model. We show that the granular packing steepest descent minimization paths act like their smooth energy landscape counterparts and get attracted by saddle points. The index versus time curves for all models follow a shifted, stretched exponential. We further show that the shape parameter for the granular packings is unchanged when the energy landscape is modified to become analytic (Gaussian potential in a harmonic well) or non-local (Mari-Krzakala-Kurchan). The $p$-spin, on the other hand, has a significantly larger shape parameter. The reason is not due to the dimensionality, packing fraction, nonanalyticity, or the locality of the Hamiltonian of the models. The exact reason for the discrepancy in the shape parameter is \st{still} an unsolved mystery.

cond-mat.soft↗