arXiv Science⌕ Search
Home/Archive/arXiv

arXiv · 1806.10662

I2C Management Based on IPbus

Shiyu Luo·Junfeng Yang·Kezhu Song·Hongwei Yu·Tengfei Chen·Tianbo Xu·Cheng Tang
View original source ↗Read source document ↗Export metadata ↓

Abstract

CBM (Compressed Baryonic Matter) is mainly used to study QCD phase diagram of strong interactions in high and moderate temperature region. Before the next generation GBTx based CBM DAQ system is built up, the DPB (Data Processing Board) layer is used in data readout and data pre-processing, where a general FPGA FMC carrier board named AFCK is used. This paper mainly describes the management of the Inter-integrated Circuit (I2C) devices on AFCK and the FMCs it carries via IPBus, an FPGA-based slow control bus used in CBM DAQ system. On AFCK, the connection of IPBus depends on the correct initialization of a set of I2C devices, including the I2C-bus multiplexer (choosing correct I2C bus), the clock crosspoint switch (providing the 125MHz needed by 1000BASE-X/SGMII), the serial EEPROM with a EUI-48 address (providing the AFCK MAC address). An independent initial module can execute an I2C command sequence stored in a ROM, through which the FPGA can write to/read from the I2C devices without IPBus, so that the related I2C devices are correctly initialized and the necessary preparation for the IPBus start-up is fulfilled. After the initialization, a Wishbone I2C master core is used as an IPbus slave and all other I2C devices can be configured directly via IPBus. All the design has been fully tested in the CBM DPB design.

Explore related subjects

physics.ins-deteess.SP

Keep this discovery

BibTeXRIS

Shiyu Luo, Junfeng Yang, Kezhu Song, Hongwei Yu, Tengfei Chen, Tianbo Xu, Cheng Tang. 2018-06-26. I2C Management Based on IPbus. https://arxiv.org/abs/1806.10662

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

High-Speed Semi-FE Readout Module for ATLAS MDT at HL-LHC: Design and Production-Level Characterization

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) introduces increased demands on the ATLAS Muon Spectrometer, particularly in terms of data throughput, timing distribution and system reliability. The Phase-II Chamber Service Module (CSM) is a key component of the upgraded Monitored Drift Tube (MDT) trigger and readout system, providing a high-speed interface between the front-end electronics and the backend systems. This paper describes the design and implementation of the Phase-II CSM, together with its validation. The results show that the CSM supports two independent optical uplinks, each operating at a line rate of 10.24 Gbps, together with clock distribution and slow control in the expected operating environment. Integration with small-diameter MDT (sMDT) chambers and tests with the prototype L0MDT trigger system are also presented. The CSM boards are now in production and will be used for installation and integration during the upcoming LHC Long Shutdown.

physics.ins-det↗
arXiv2026

Spectral Discrimination of Deposited Gamma-Ray Energies in a Simulated CeBr$_3$ Scintillator

We show that wavelength measurements of individual detected optical photons may provide additional information about gamma-ray energy deposited in a CeBr$_3$ crystal when the detected-photon-count distributions overlap for nearby gamma-ray energies. Monoenergetic 662 and 629 keV gammas are used in a Geant4 simulation of a $25\times25\times20~\mathrm{mm^3}$ CeBr$_3$ crystal. Assuming a light yield of $6.0\times10^4$ photons/MeV, a wavelength-independent photon-detection efficiency of 30%, and a wavelength resolution of $\sigma_{\lambda}=40$ nm, we find that the fraction of photons reconstructed above 385 nm gives an event-level separation of $\sim$ 2 standard deviations between the 662 and 629 keV event populations selected within the same $\sim$ 1%-wide detected-photon-count interval. No timing or reconstructed interaction-position information is used. The result demonstrates, within the present simulation model, that event-dependent optical spectra can retain energy information beyond an undifferentiated photon count.

physics.ins-det↗
arXiv2026

Operation of a negative ion gas time projection chamber without electronegative fill gases

The high fidelity reconstruction of particle tracks in micropatterned gaseous time projection chambers renders this technology ideal for future rare-event searches, including direction-sensitive dark matter experiments. Large drift distances are typically required for such experiments, so that the overall spatial resolution is limited by diffusion. Negative ion drift exhibits lower diffusion than electron drift and is thus an attractive option for realising a large-scale detector. The use of electronegative gases to create negative ions introduces technical challenges, most notably a reduction in gain when compared to conventional gas mixtures. In this study, we demonstrate a new method for negative ion generation via dissociative electron attachment using the conventional molecular fill gas CF$_4$. Our optical measurements of negative ion drift indicate electron attachment lengths of $<$1 mm and comparable gain to electron avalanches. The individual negative ion avalanches were also time-resolved, allowing the number of ions reaching the readout to be counted. We measure an improved energy resolution by single ion counting, relative to an integrated electron avalanche signal measured under identical gain conditions.

physics.ins-det↗