arXiv ScienceSearch

arXiv · 1806.02645

Ultra-precision DC source for Superconducting Quantum Computer

Abstract

The Superconducting Quantum Computing (SQC) is one of the most promising quantum computing techniques. The SQC requires precise control and acquisition to operate the superconducting qubits. The ultra-precision DC source is used to provide a DC bias for the qubit to work at its operation point. With the development of the multi-qubit processor, to use the commercial precise DC source device is impossible for its large volume occupation. We present our ultra-precision DC source which is designed for SQC experiments in this paper. The DC source contains 12 channels in 1U 19~inch crate. The performances of our DC source strongly beat the commercial devices. The output rang is -7~V to +7~V with 20~mA maximum output current. The Vpp of the output noise is 3~uV, and the standard deviation is 0.497~uV. The temperature coefficient is less than 1~ppm/$^{\circ}$C in 14~V range. The primary results show that the total drift of the output within 48h at an A/C room temperature environment is 40~uV which equal to 2.9~ppm/48h. We are still trying to optimize the channel density and long-term drift / stability.

Explore related subjects

Keep this discovery

BibTeXRIS

Futian Liang, Peng Miao, Jin Lin, Yu Xu, Cheng Guo, Lihua Sun, ShengKai Liao, Ge Jin, ChengZhi Peng. 2018-06-07. Ultra-precision DC source for Superconducting Quantum Computer. https://arxiv.org/abs/1806.02645

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

High-Speed Semi-FE Readout Module for ATLAS MDT at HL-LHC: Design and Production-Level Characterization

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) introduces increased demands on the ATLAS Muon Spectrometer, particularly in terms of data throughput, timing distribution and system reliability. The Phase-II Chamber Service Module (CSM) is a key component of the upgraded Monitored Drift Tube (MDT) trigger and readout system, providing a high-speed interface between the front-end electronics and the backend systems. This paper describes the design and implementation of the Phase-II CSM, together with its validation. The results show that the CSM supports two independent optical uplinks, each operating at a line rate of 10.24 Gbps, together with clock distribution and slow control in the expected operating environment. Integration with small-diameter MDT (sMDT) chambers and tests with the prototype L0MDT trigger system are also presented. The CSM boards are now in production and will be used for installation and integration during the upcoming LHC Long Shutdown.

physics.ins-det

Spectral Discrimination of Deposited Gamma-Ray Energies in a Simulated CeBr$_3$ Scintillator

We show that wavelength measurements of individual detected optical photons may provide additional information about gamma-ray energy deposited in a CeBr$_3$ crystal when the detected-photon-count distributions overlap for nearby gamma-ray energies. Monoenergetic 662 and 629 keV gammas are used in a Geant4 simulation of a $25\times25\times20~\mathrm{mm^3}$ CeBr$_3$ crystal. Assuming a light yield of $6.0\times10^4$ photons/MeV, a wavelength-independent photon-detection efficiency of 30%, and a wavelength resolution of $\sigma_{\lambda}=40$ nm, we find that the fraction of photons reconstructed above 385 nm gives an event-level separation of $\sim$ 2 standard deviations between the 662 and 629 keV event populations selected within the same $\sim$ 1%-wide detected-photon-count interval. No timing or reconstructed interaction-position information is used. The result demonstrates, within the present simulation model, that event-dependent optical spectra can retain energy information beyond an undifferentiated photon count.

physics.ins-det

Operation of a negative ion gas time projection chamber without electronegative fill gases

The high fidelity reconstruction of particle tracks in micropatterned gaseous time projection chambers renders this technology ideal for future rare-event searches, including direction-sensitive dark matter experiments. Large drift distances are typically required for such experiments, so that the overall spatial resolution is limited by diffusion. Negative ion drift exhibits lower diffusion than electron drift and is thus an attractive option for realising a large-scale detector. The use of electronegative gases to create negative ions introduces technical challenges, most notably a reduction in gain when compared to conventional gas mixtures. In this study, we demonstrate a new method for negative ion generation via dissociative electron attachment using the conventional molecular fill gas CF$_4$. Our optical measurements of negative ion drift indicate electron attachment lengths of $<$1 mm and comparable gain to electron avalanches. The individual negative ion avalanches were also time-resolved, allowing the number of ions reaching the readout to be counted. We measure an improved energy resolution by single ion counting, relative to an integrated electron avalanche signal measured under identical gain conditions.

physics.ins-det