arXiv ScienceSearch

arXiv · 1705.03684

Fourier-Correlation Imaging

Abstract

We investigate to what extent correlating the Fourier components at slightly shifted frequencies of the fluctuations of the electric field measured with a one-dimensional antenna array on board of a satellite flying over a plane, allows one to measure the two-dimensional brilliance temperature as function of position in the plane. We find that the achievable spatial resolution resulting from just two antennas is of the order of $hχ$, with $χ=c/(Δr ω_0)$, both in the direction of flight of the satellite and in the direction perpendicular to it, where $Δr$ is the distance between the antennas, $ω_0$ the central frequency, $h$ the height of the satellite over the plane, and $c$ the speed of light. Two antennas separated by a distance of about 100m on a satellite flying with a speed of a few km/s at a height of the order of 1000km and a central frequency of order GHz allow therefore the imaging of the brilliance temperature on the surface of Earth with a resolution of the order of one km. For a single point source, the relative radiometric resolution is of order $\sqrtχ$, but for a uniform temperature field in a half plane left or right of the satellite track it is only of order $1/χ^{3/2}$, indicating that two antennas do not suffice for a precise reconstruction of the temperature field. Several ideas are discussed how the radiometric resolution could be enhanced. In particular, having $N$ antennas all separated by at least a distance of the order of the wave-length, allows one to increase the signal-to-noise ratio by a factor of order $N$, but requires to average over $N^2$ temperature profiles obtained from as many pairs of antennas.

Explore related subjects

Keep this discovery

BibTeXRIS

Daniel Braun, Younes Monjid, Bernard Rougé, Yann Kerr. 2017-05-10. Fourier-Correlation Imaging. https://doi.org/10.1063/1.5017680

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

High-Speed Semi-FE Readout Module for ATLAS MDT at HL-LHC: Design and Production-Level Characterization

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) introduces increased demands on the ATLAS Muon Spectrometer, particularly in terms of data throughput, timing distribution and system reliability. The Phase-II Chamber Service Module (CSM) is a key component of the upgraded Monitored Drift Tube (MDT) trigger and readout system, providing a high-speed interface between the front-end electronics and the backend systems. This paper describes the design and implementation of the Phase-II CSM, together with its validation. The results show that the CSM supports two independent optical uplinks, each operating at a line rate of 10.24 Gbps, together with clock distribution and slow control in the expected operating environment. Integration with small-diameter MDT (sMDT) chambers and tests with the prototype L0MDT trigger system are also presented. The CSM boards are now in production and will be used for installation and integration during the upcoming LHC Long Shutdown.

physics.ins-det

Spectral Discrimination of Deposited Gamma-Ray Energies in a Simulated CeBr$_3$ Scintillator

We show that wavelength measurements of individual detected optical photons may provide additional information about gamma-ray energy deposited in a CeBr$_3$ crystal when the detected-photon-count distributions overlap for nearby gamma-ray energies. Monoenergetic 662 and 629 keV gammas are used in a Geant4 simulation of a $25\times25\times20~\mathrm{mm^3}$ CeBr$_3$ crystal. Assuming a light yield of $6.0\times10^4$ photons/MeV, a wavelength-independent photon-detection efficiency of 30%, and a wavelength resolution of $\sigma_{\lambda}=40$ nm, we find that the fraction of photons reconstructed above 385 nm gives an event-level separation of $\sim$ 2 standard deviations between the 662 and 629 keV event populations selected within the same $\sim$ 1%-wide detected-photon-count interval. No timing or reconstructed interaction-position information is used. The result demonstrates, within the present simulation model, that event-dependent optical spectra can retain energy information beyond an undifferentiated photon count.

physics.ins-det

Operation of a negative ion gas time projection chamber without electronegative fill gases

The high fidelity reconstruction of particle tracks in micropatterned gaseous time projection chambers renders this technology ideal for future rare-event searches, including direction-sensitive dark matter experiments. Large drift distances are typically required for such experiments, so that the overall spatial resolution is limited by diffusion. Negative ion drift exhibits lower diffusion than electron drift and is thus an attractive option for realising a large-scale detector. The use of electronegative gases to create negative ions introduces technical challenges, most notably a reduction in gain when compared to conventional gas mixtures. In this study, we demonstrate a new method for negative ion generation via dissociative electron attachment using the conventional molecular fill gas CF$_4$. Our optical measurements of negative ion drift indicate electron attachment lengths of $<$1 mm and comparable gain to electron avalanches. The individual negative ion avalanches were also time-resolved, allowing the number of ions reaching the readout to be counted. We measure an improved energy resolution by single ion counting, relative to an integrated electron avalanche signal measured under identical gain conditions.

physics.ins-det